Speed restrictor ramps

These modular units can be arranged and installed to effect and reduce the speed of on-coming traffic on most sites or locations. Comprising of modular segments in either 50 mm or 70 mm high they are coloured in either high visibility yellow or black, which simply slot together on site. Typically alternate colours are laid to aid visibility.

Units can be fixed in the ‘short term’ by use of an adhesive and later relocated and bolted down for permanent fixing. It is recommended that ‘speed warning signs’, (shown left), are also used in conjunction with any speed ramp installation to warn approaching traffic of their presence.

Specification

500 mm long units manufactured in ‘heavy duty’ rubber supplied in either yellow or black.
Available in 50 mm high to reduce site traffic to 10 MPH
Or in 70 mm high to reduce on-coming traffic speeds to 5 MPH.
End cap modules are 250 mm long and are supplied in pairs to suit either height system

Fixing

It’s recommended that sections are fixed using anchor bolts to a level concrete surface.
Each 500 mm long central segment requires 4 no. anchor bolts
Each end cap requires 2. no anchor bolts.
Bolts should be a minimum of 150 mm long, (M12 type).

Recommendations

Adequate illumination at night required.
Clear warning signage.

For more information about any of the products featured on this page contact our sales department.

Speed ramp in action

Demonstration of speed ramp
functionality

Speed restriction sign